Knurling ToolsPressure Knurling Our forming type knurls are manufactured to extremely high standards from premium alloys. Most of our knurls are furnished with a lapped tooth form to give longer life and impart a smooth, clean surface to the knurled part. Both sides and the bore of the knurl are finish ground to maintain close tolerance on diameter and side runout. Our standard material is a high quality grade of High Speed steel which is vacuum hardened, and tempered at least 2 times to a hardness of about 63 Rockwell C. For severe knurling operations, such as rolling on 303 stainless or semi-hardened steels, We also offer knurls in a super premium grade of high-cobalt steel. These knurls are slightly harder and in most applications deliver a substantial increase in tool life. Multiple coatings such as TiN and ferritic nitrocarburizing are also available if required. Our sales representatives will be happy to discuss any apect of your knurling application and make recomendations on maximizing tool life versus cost for any type of knurling operation. In addition to the many stock knurling dies shown below, we can supply virtually any size and pitch special knurls with 1-2 week normal delivery for standard knurl tooth forms. Cut Knurling Cut knurling with sharp edged knurls, actually cuts the material like a milling tool. Cut knurl holders of the types K10 and K11 in the Knurltec range hold the knurls at an angle to the work piece, producing a very high quality knurl that closely retains the pre machined diameter. This method is particularly good and recommended for the knurling of nonferrous material such as brass and aluminum, as well as harder metals. Pressure knurling of brass and aluminum can cause the crests to become over worked and brittle which may cause them to break, cut knurling eliminates that possibility, and is highly recommended for a quality look and feel. Cut knurling uses much less force than conventional pressure knurling putting less strain on the machine tool and making it more suitable for machining tubular parts. Not suitable for knurling up to a shoulder due to the angular arrangement of the knurls. Cut knurling is essential for machining plastics and cast iron, where pressure would impede material flow. Last Updated: Friday, 08 November 2024 01:48 |
Navigation
Secure ShoppingSearch ProductsFeatured Products |